Why is My Refrigerator Water Dispenser Not Working?

defective refrigerator water dispenser

Is the water dispenser on your refrigerator not dispensing water? If not, you can attempt to solve the problem by yourself or call Pride Vacaville Appliance Repair for refrigerator repair Vacaville, California.

There are many reasons for the water dispenser in a kitchen refrigerator to stop working. Again, some of the suggestions are going to sound a little strange. However, something as simple as a power switch has been the culprit in the past. Be sure to inspect the obvious potential issues before moving forward with refrigerator repair. Let’s start to tackle this appliance repair issue and see all of the solutions we can cite for a broken water dispenser.

The cause of a water dispenser not working is usually either an installation problem, a filter issue or frozen water lines:

New Refrigerator Installation Issues

You just installed a new refrigerator for your kitchen with a water dispenser, but it is not working. The water dispenser must be hooked up to the water line. That could be the issue.

If your brand new refrigerator is replacing an old refrigerator that didn’t include an ice maker or water dispenser, there is a chance that you don’t have a functioning water line running to this area. A water line is typically run from under a home either in a basement or crawl space. You can buy this line at just about any hardware store and they’re very easy for the typical homeowner to install. Typically they have come with a water shut-off valve, which is necessary so that if you should need to move the refrigerator, you can shut off the water.

If you have an attached water line, is the valve on? The valve handle should be in line with the hose. And, is water running through the pipe you have used to connect the water line? Simple and basic questions, but things that have to be accounted for.

If you had to remove the refrigerator doors during installation it’s possible the water dispenser might not be plugged in. Read the owner’s manual to see the wire harness for that particular model of refrigerator. Ensure that it is plugged into the refrigerator.

If the water is hooked up, most of the time there is air in the line. So, engaging and disengaging the water dispenser control to get the air out is necessary.
Filter Problems

On some of the household models, there are different filters. These filters can “expire”, clog or get frozen. All of the filters are based on the model and brand of refrigerator. If your filter is blocked it might cause slow filling or no flowing. It is recommended that your filter is replaced every 6 months. Changing filters can be difficult. If you have issues, go online and learn the right process to replace a filter.

One idea is to fill the water filter with water prior to installation. A lot of time the water filters will need a long time to fill, which could cause you to think the water dispenser on the refrigerator isn’t working. You should read the manual if nothing is working. To be sure it’s not air trapped in the lines, depress the dispenser lever for around 5 minutes.

A frozen water tank might also be the reason for the issue as well on some models. If the tank is frozen it will leak onto the food bins. Limited food in the fresh food bins will cause freezing.

ADDITIONAL REFRIGERATOR RESOURCES